Using Auto Memory Store (Ams) - Radio Shack HTX-242 Owner's Manual

7. Press
8. Rotate
9. Press
10. Rotate
11. For the calling-frequency memory, press

Using Auto Memory Store (AMS)

Follow these steps to have the HTX-242 scan through a selected
range and store active frequencies in memory.
1. Set the upper and lower scan limits (see "Setting the Scan-
2. Set the scanning step (see "Setting the Frequency Step" on
3. Set the squelch (see "Setting Volume and Squelch" on
4. Hold
5. To stop auto store before all memories are used, press
Notes:
!
•
•
. The HTX-242 displays
subaudible tone.
, or press
TUNE
change the receive subaudible tone.
. The HTX-242 displays
subaudible tone.
, or press
TUNE
change the transmit subaudible tone.
settings.
For a standard memory, press
Sn . Rotate , or press
TUNE
select whether the memory is included in a memory scan
( On ) or locked out of a memory scan (
save all settings.
ning Range" on Page 21).
Page 19).
Page 17).
for at least 1 second. Then press
F
The HTX-242 scans between the lower and upper scan lim-
its. When it detects a transmission, it checks all memories to
see if that frequency is already stored. If the frequency is not
in a memory, the HTX-242 stores the frequency in the lowest
unused memory, then resumes scanning. The HTX-242 con-
tinues auto store until all memories are used.
, , , or .
DUP MR CALL MHz
The HTX-242 turns off tone squelch during auto store.
Auto store does not work if all memories are used.
rC and the current receive
or on the microphone, to
UP DOWN
and the current transmit
tC
or on the microphone, to
UP DOWN
CALL
. The HTX-242 displays
or on the microphone, to
UP DOWN
Off ). Then press
.
MHz
to save all
to
MR
,
VFO
29