Table of Contents
Advertisement
T
roubleshooting
Vacuum cleaner won't run
Possible causes
1. Vacuum cleaner is not plugged in
2. Power button is not pressed down
Vacuum cleaner won't pick up or low suction
Possible causes
1. Tools, hose and/or extension wands are blocked
2. Filters are dirty
3. Dirt cup is full
4. Hose connector not securely attached to suction inlet
5. Crack or hole in hose
6. Air flow regulator is set to open or
minimum setting
7. Clog in the dirt cup
Visible dust escaping from vacuum
Possible causes
1. Dirt cup is full
2. Filters missing or installed incorrectly
3. Filters are dirty
4. Hose is blocked
5. Hose connector not securely attached to suction inlet
6. Crack or hole in hose
other maintenance or service not included in the manual should be performed by an
thank you for selecting a bISSEll product.
Please do not return this product to the store.
w w w . b i s s e l l . c a
WaRnInG:
to reduce the risk of electric shock,
turn power off and disconnect
plug from electrical outlet before
performing maintenance or
troubleshooting.
Remedies
1. Check electrical plug
2. Press power button down
Remedies
1. Remove each part and check for blockages
2. Check and clean or replace all filters
3. Empty dirt cup
4. Make sure hose connector is locked into
5. Check hose and replace if needed
6. Change to closed or maximum setting
7. Clear clog from dirt cup following
Remedies
1. Empty dirt cup
2. Check all filters for correct installation
3. Check and clean or replace all filters
4. Remove hose and check for
blockages
5. Make sure hose connector is locked into
suction inlet
6. Check hose and replace if needed
authorized service representative.
suction inlet
instructions on page 12
1 - 8 0 0 - 2 6 3 - 2 5 3 5
13
Advertisement
Table of Contents
