Required Tools For Setup; Setup; Step 1: Check Box For Contents; Step 2: Remove The Sim Door - Cradlepoint R1900 Series Installation Manual

applicable charges regardless of whether the router uses a wired or wireless Internet connect. To avoid
such data usage and potential charges, refer to

Required Tools for Setup

Cradlepoint recommends that a professional install the R1900 in any environment. However, the
following tools may be necessary for setup.
• #0 Philips-head screwdriver (for SIM cover screws)
• #2 Philips-head screwdriver (for mounting screws)
• Mounting tools - Depending on the location of installation, additional mounting tools may be
necessary. These tools may include, but are not limited to:
o Screwdrivers
o Drill and drill bits
o Additional screws
o Zip ties

Setup

Refer to the following for general setup instructions.

STEP 1: Check box for contents.

Prior to having the R1900 router installed, open the box and ensure that all items are present. You
should have received the following:
•
[1] R1900 series router
•
[1] 3-meter (2x2) Power and GPIO cable
•
[4] M4 screws, nuts, and washers
•
[1] Mounting template
•
[1] Quick Start Reference sheet
•
[1] Safety, Warranty, and Regulatory guide
Accessories
To optimize the R1900 series router for Wireless WAN or with failover configuration, you will need at
least one activated 4FF-sized SIM card, with an active cellular data plan.
Additional accessories to enhance your router capabilities include, but are not limited to:
• OBDII cable
• RX30-POE
• Antennas
o Refer to the
Approved vendor.

STEP 2: Remove the SIM door.

Router Communication/Data Usage
Cradlepoint Antenna webpage for assistance in locating a Cradlepoint
for more information.