Table of Contents
Advertisement
WATER DRAINAGE
When the unit is in cooling mode, unwanted water is extracted from the air. Most of this water is re-used to cool the unit and
make it run more efficiently. When the unit is used in extremely humid environments, water will collect in a water container at
the bottom of the unit. When the water container is full, the compressor will stop but the fan will continue to run.
When the water container is full, the unit will display 'FULL or
resume operation, empty the water container according to the following steps:
1. Turn the unit off. Do not move the unit when the water container is full.
2. Place the drain pan accessory under the drainage port at the back of the unit.
3. Remove the rubber plug from the drain hole. The condensate water will drain out automatically. When the drain pan
is full, replace the rubber plug into the drainage hole to stop the water flow. Empty the drain pan. Repeat until all the
water is emptied.
4. Once the water container has been emptied, replace the rubber plug into the drain hole firmly. Do not allow the water
to drip continuously into the drain pan, as it might easily overflow.
NOTE: In heating mode, the drain pipe accessory must be used to empty the water container.
1. Remove the rubber plug and keep for future use.
2. Connect the drain tube accessory to the drain hole. Place drain pan at end of drain tube; water will drain out
automatically during operation.
HIGH HUMIDITY WATER RELEASING FEATURE
When used in high humidity areas, more water can be created than the unit can re-use, when this happens the internal tank
will fill up, cooling will stop and the unit requires emptying. The PAC18 model features a water releasing function, this allows
you to connect a water drain pipe to the upper water removal port and thus allows continuous use of the machine without fear
of it turning itself off. When this feature is desired connect the 3m water pipe to the port then drain the water (making sure
the water goes downhill!), if this feature is not required please ensure the plastic screw lid is tightly secured to the upper
drainage port.
Automatic freeing port position following chart :
Automatic
freeing
port
' on the control panel until the tank is emptied. To
(PAC18)
15
Automatic
freeing
port
Advertisement
Table of Contents
