Installation And Hook-Up - Audiovox AWM930 Owner's Manual

1) Cut mounting hole in desired location using mounting hole
diagram (right)
2) Route power, speaker, and antenna cables through hole,
and connect to unit as shown in hook up diagram below.
3) After making sure connections are correct, test unit
operation as described in the operation section (Do not
mount until AM antenna trimmer adjustment has been
made.
WIRING COLOR CODE
FOR AWM-930
COLOR
ORANGE/WHITE
GREEN/WHITE +12VDC BATTERY POWER
BLACK/WHITE
WHITE
VIOLET
BLUE
GREEN
RED
VIOLET/BLACK
YELLOW
GREEN/BLACK
NOTE: Always be sure when running cables to avoid sharp edges, extreme heat sources, and any other
potential hazards.
INSTALLATION AND HOOK UP
FUNCTION
+12VDC IGNITION POWER
TO CHASSIS GROUND
LEFT (A) SPEAKER (+)
LEFT (A) SPEAKER (-)
RIGHT (A) SPEAKER (+)
RIGHT (A) SPEAKER (-)
LEFT (B) SPEAKER (+)
LEFT (B) SPEAKER (-)
RIGHT (B) SPEAKER (+)
RIGHT (B) SPEAKER (-)
NOTES:
- Speakers must have a minimum of four
impedance each.
- Either antenna may be used. Both do not
have to be hooked up at the same time.
- Do not operate this unit with only one
speaker hooked up. If a speaker fails,
replace it before operating this unit.
2