Cleaning The Pre-Filter; Cleaning External Surfaces; Uv Lamp - Therapure TPP640S Manual

CLEANING THE PRE-FILTER

1. Release the air inlet grill by pressing on the lock-
ing latch.
2. Gently remove the pre-filter from the air inlet
grill.
3. To clean the pre-filter, simply submerge in warm
soapy water. Gently lift and submerge the pre-
filter several times until it is clean.
4. Rinse the pre-filter with clean water and allow it
to dry completely before placing it back to the air
inlet grill.

CLEANING EXTERNAL SURFACES

1. Turn off and unplug unit.
2. Use a washcloth slightly dampened with a little
water and dishwashing soap to wipe the outer
case surfaces.
3. Do not allow water to slip into the internal parts
as this could damage your unit and result in elec-
trical shock and injury to you.
4. Allow the unit to thoroughly dry before use.

UV LAMP

The lifetime of the UV lamp is up to 12 months
of continuous, effective operation. After this
time, the bulb may remain illuminated, but its ef-
fectiveness is greatly reduced. For maximum effec-
tiveness, replace the UV bulb annually.
Do not touch the glass part of the lamp. Oil
from fingertips will decrease the effective-
ness of the lamp.
Never operate the unit without a filter or with
a damaged filter. UV lamp cover must be in-
stalled at all times. The UV light from the UV lamp
will result in severe damage to eyes and could cause
blindness.
29
en