Volume Punch-Through - Harman Kardon AVR35RDS User Manual

Erasing All the Learned Commands For
a Single Device
To erase all the commands for a single
device, follow these steps:
1. Press the
Device Control Selector
for the desired device (e.g., CD,
c
TV, VCR etc.) and the
Set
at the same time until the LED under
the
Device Control Selector
red and the
Program/Command
a
turns and remains
Indicator
orange.
2. Press and hold the
Direct
. The
s
Program/Command
Indicator a will flash red five
times, and the red LED under the
Device Control Selector c
will turn off.
3. Release the button
Direct
Program/Command Indicator a
will flash green twice, and then turn to
a steady orange color. The red LED
under the
Device Control Selector
will turn back on.
c
4. At this point, all the learned codes for
the device have been erased. To com-
plete the process, press and hold the
Device Control Selector c
the button at the same time
j
Set
until the
Program/Command
Indicator a flashes orange twice
and then goes out, and the red LED
under the
Device Control Selector
turns off.
AVR35RDS 230 volt Rev (C) 9/28/98
Programming the Remote
Erasing All Learned Commands
To erase ALL commands that have been
learned to all buttons in the remote, fol-
low the instruction shown below. Note that
this will erase all commands for the CD,
TAPE, SAT, TV, VCR and CBL devices, but it
will not erase the commands for the
AVR35RDS, itself.
button j
turns To erase all learned commands, press
and hold the
TV Device Control
Selector c
at the same time until the
Command Indicator a
ten times, then green once and orange
button
once. When the
Indicator a
off, release the buttons. All learned com-
mands have been erased from the
AVR35RDS remote control.

Volume Punch-Through

and the
s
The AVR35RDS's remote may be pro-
grammed to operate the
Control
from either the TV or the AVR to operate
in conjunction with any of the eight
devices controlled by the remote. For
example, since the AVR35RDS will likely
be used as the sound system for TV view-
ing, you may wish to have the AVR's vol-
and
ume activated when the remote is set to
run the TV. Either the AVR or TV volume
control may be associated with any of the
remote's devices.
32
and the button s
Direct
Program/
flashes red
Program/Command
stops flashing and turns
Volume
and button
`
Mute
To program the remote for Volume
Punch-Through, follow these steps:
1. Press the
Device Control Selector
for the device you wish to have
c
associated with the volume control
(e.g., TV, SAT, etc.) and the
button at the same time until the
`
red light illuminates under the
Device Control Selector
2. Press the button
Volume Up
3. Press either the or the
AVR b
TV Device Control Selector
, depending on which system's
c
volume control you wish to have
attached for the punch-through
mode. Note that the red light under
the
Device Control Selector
will blink twice and then go out to
confirm the data entry.
Example: To have the AVR's vol-
ume control be activated even
though the remote is set to control
the TV, first press the
TV Device
, and the
Control Selector c
button at the same time.
`
Mute
Next, press the
Volume Up
, followed by the
AVR Device
.
Control Selector b
NOTE: Should you wish to return the
remote to the original configuration after
entering a Volume Punch-Through, you
will need to repeat the steps shown above.
However, press the same Device Control
Selector in steps one and three.
Mute
.
.
button