Volume Punch-Through; Re-Assigning Device Control Selectors - Harman Kardon AVR45 Owner's Manual

After following these steps, each time
you press the button
Power
remote will send the Power On/Off
command each time the Power
button is pressed.
To remove a macro program, follow steps
1, 2 and 4 above, but do not follow step
three. For example, to erase the macro
just entered, press the
Device Control
b
and the
Selector Mute
d
at the same time until the red light
under the Device Control Selector turns
on. Press the button
Power
then press the button
Sleep
red light under the
Device Control
will blink twice to confirm the
Selector
data entry and then turn off.

Volume Punch-Through

The AVR45's remote may be programmed
to operate the
Volume Control
from either the TV or the AVR to operate in
conjunction with any of the eight devices
controlled by the remote. For example,
since the AVR45 will likely be used as the
sound system for TV viewing, you may
wish to have the AVR's volume activated
although the remote is set to run the TV.
Either the AVR or TV volume control may
be associated with any of the remote's
devices. To program the remote for Volume
Punch-Through, follow these steps:
Programming the Remote
1. Press the
c b
, the for the unit you wish to have asso-
ciated with the volume control and the
Mute
until the red light illuminates under
the
Device Control Selector
2. Press the
3. Press either the
button
TV Device Control Selector
b
, depending on which system's
volume control you wish to have
c
, and attached for the punch-through mode.
`
. The Note that the red light under the
Device Control Selector
twice and then go out to confirm the
data entry.
Example: To have the AVR's vol-
ume control be activated even
though the remote is set to control
z
the TV, first press the
Control Selector
Mute
Next, press the
z
Control Selector
NOTE: Should you wish to return the
remote to the original configuration after
entering a Volume Punch-Through, you
will need to repeat the steps shown above.
However, press the
Selector in steps one and three.
31
Device Control Selector
d
button at the same time
.
z
button
Volume Up
a
or the
AVR
will blink
TV Device
b , and the
button d at the same time.
button
Volume Up
, followed by the
AVR Device
a
.
same Device Control
Re-Assigning Device Control
Selectors
Although each of the seven
Control Selectors
assigned to the category of product shown
on the remote, it is possible to re-assign
one of these buttons to operate a second
.
device of another type. For example, if you
have two VCRs, but no satellite receiver,
you may program the "SAT" button to
operate a second VCR. Before following
the normal programming steps for either
Three-Digit entry or Auto Search code
entry, you must first re-assign the button
with the following steps:
1. Press the
Device Control Selector
b
you wish to re-assign and the
d
button
Mute
until the red light illuminates under
the
Device Control Selector
2. Press the
Device Control Selector
b
for the function you wish to
program into the re-assigned button.
3. Enter the three-digit code for the spe-
cific model you wish the re-assigned
button to operate.
4. Press the same
pressed in Step 1 again to
Selector
store the selection.
Example: To use the SAT button to
operate a second VCR, first press the
SAT Device Control Selector
b
, and the
the same time until the red light
glows under the SAT button. Press
the VCR button, followed by the
three-digit code for the specific
model you wish to control. Finally,
press the SAT button again.
Device
b
is normally
at the same time
.
Device Control
d
button at
Mute