Advertisement
F3UV
Specifications
J RATINGS/CHARACTERISTICS
Monitors with Built-in Amplifiers (Main Unit)
Item
Incident light power range
(See Note 1)
Incident light wavelength range
Power indicator
Operation indicator
Sensitivity adjustment
Power supply voltage
Current consumption
Response time (See Note 2)
Output (See Note 3)
Connection impedance
Repeatability
Temperature drift
Ambient operating illumination
(See Note 4)
Ambient temperature
Ambient humidity
Insulation resistance
Dielectric strength
Vibration resistance
Shock resistance
Degree of protection
Connection method
Weight (packed)
Material
Accessories
Note: 1. Using a standard UV light source and UV illumination meter in a power range for which analog output can be set to 5 V.
2. The response time is the rise time of the output signal.
3. An output voltage up to 6 V can be output. Adjust the sensitivity so that the output is less than 5 V. The output is 0.2 to 1 V
when there is no incident UV light.
4. This value is the illumination at the receiver window maintaining an offset voltage of 1 V max. with the fluorescent light.
F3UV-A30
2
1 to 30 mW/cm
200 to 370 nm
Green LED
Orange LED (lights with an output between 4 and 5 V)
One-turn potentiometer
12 to 24 VDC ±10%
15 mA max.
300 ms max.
1 to 5 V (with an offset voltage of 0.2 V min.)
100 kW min.
±2% Full Scale max.
0.2% of Full Scale/°C max.
Fluorescent light 1,000 lux max.
Operating: --10° to 70°C (14° to 158°F) Storage: --25° to 80°C (--13° to 176° F)
Operating: 35% to 85%
20 MW min. (at 500 VDC)
1,000 VAC 50/60 Hz for 1 min
10 to 150 Hz, 0.1-mm amplitude in X, Y, and Z directions
(8 minutes of vibration ´ 10 repetitions= total time of 80 minutes)
2
150 m/s
three times each in the ±X, ±Y, and ±Z directions approximately 1.5 G
Conforms to IEC IP30
Pre-wired cable with a standard length of 2 m
78 g (2.75 oz)
Casing: die-cast zinc
Window: synthetic quartz glass
Operation Manual
F3UV-A03
2
0.2 to 3 mW/cm
400 ms max.
Fluorescent light 500 lux max.
F3UV
3
Advertisement
