Storage; Returning To Service - Coleman POWERSPORTS RTK200 Owner's Manual

STORAGE

If the Go-Kart is left unused for an
extended period of time proper
storage maintenance is required.
1. Wash Go-Kart thoroughly, thenwax
painted parts with a non abrasive
auto wax. Coat vinyl seat and rubber
parts with a vinyl/rubber protect ant.
Note: Keep water away from air
intake and muffler outlet while
washing to avoid water from entering
the engine and/or components.
2. Drain carburetor by placing fuel
valve (1) to the off (left) positionand
opening the drain screw (2). Allow all
fuel to drain from the carburetor.
Once fuel is drained, re-tighten drain
screw (2).
Note: Make sure to drain fuel ina
proper storage container.
3. Fill fuel tank to full with gasoline
mixed with fuel stabilizer as
recommended by the fuel stabilizer
manufacture.
Note: Fuel stabilizer can be
purchased at mostmotorcycle shops
and auto parts stores.
4. Remove spark plug and poor 1
tablespoon of motor oil in thespark
plug hole. Re-install spark plug.
5. Place the starter switch to the off
position and pull the start recoil cord
a few times. This is to coat theinside
cylinder head with oil.
6. Fill tires with correct air pressure.
7. If possible, store Go-Kart in a shed
or garage with a cover to protectfrom
dust, dirt and humidity. If the Go-Kart
must be stored outdoors, cover com-
pletely with a good waterproof cover.
MAINTENANCE

Returning to service

1. Wash Go-Kart thoroughly.
Note: Keep water away from
air intake and muffler outlet
while
washing to avoid water from
entering the engine and/or
components.
2. Drain engine oil and replace
with fresh clean oil as listed inthis
manual.
3. Review this owner's manual
and follow the pre-ride inspection
procedures.
4. Start engine by following the
starting procedures in thismanual.
32
1
2