Table of Contents
Advertisement
1. Turn the Resistance Control (26) counterclockwise to
the minimum setting.
If the Resistance Control (26) is attached to the
Upright (3), remove the M4 x 16mm Screw (34). Pull
the bottom of the Resistance Control away from the
Upright and then slide it down to release it. Do not
pull on the Resistance Control or remove it from
the Upright.
2. Lay a cloth over the front of the Frame (1) to protect
it. Lay the Upright (3) in the position shown. Connect
the Extension Wire (2) to the Reed Switch Wire (25).
Next, connect the Resistance Cable (26) to the
Extension Cable (55) in the following way:
• Refer to drawing A. Pull up on the metal bracket,
and insert the tip of the Resistance Cable (26) into
the wire clip on the Extension Cable (55) as shown.
• Refer to drawing B. Firmly pull the Resistance
Cable (26) and slide it into the metal bracket on the
Extension Cable (55) as shown.
• Refer to drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
3. Align the two holes in the front of the Upright (3) with
the two welded bolts on the front of the Frame (1).
Carefully push the Reed Switch Wire (not shown) into
the Upright until there is no slack.
Next, pivot the Upright (3) about halfway to the verti-
cal position while guiding the metal bracket on the
Extension Cable (not shown) into the Upright. Once
the top edge of the metal bracket is inside the
Upright, pivot the Upright to the vertical position so it
rests on the four welded bolts on the Frame (1). Be
careful to avoid pinching the wires. Tighten an M10
Nylon Locknut (29) onto each welded bolt.
Refer to step 1. Reattach the Resistance Control (26)
to the Upright (3) with the M4 x 16mm Screw (34).
All manuals and user guides at all-guides.com
6
1
3
2
3
2
1
25
B
A
Metal
Bracket
26
26
55
55
3
3
1
Tab
26
34
26
55
C
26
55
29
Welded
Bolts
Advertisement
Table of Contents
