Installing The Hob; Safety Instructions For The Installer - Samsung NZ84F7NC Series User Manual

Installing the hob

Be sure the new appliance is installed and grounded only by
qualified personnel.
WARNING
Please observe this instruction. The warranty will not cover
any damage that may occur as a result of improper
installation. Technical data is provided at the end of this
manual.

SAFETY INSTRUCTIONS FOR THE INSTALLER

• A device must be provided in the electrical installation that
allows the appliance to be disconnected from the mains at all
poles with a contact opening width of at least 3 mm. Suitable
isolation devices include line protecting cut - outs, fuses
(screw type fuses are to be removed from the holder), earth
leakage trips and contactors.
• With respect to fire protection, this appliance corresponds to
EN 60335-2-6. This type of appliance may be installed with a
high cupboard or wall on one side.
• Drawers may not be fitted underneath the hob.
• The installation must guarantee shock protection.
• The kitchen unit in which the appliance is fitted must satisfy
the stability requirements of DIN 68930.
• For protection against moisture, all cut surfaces are to be
sealed with a suitable sealant.
• On tiled work surfaces, the joints in the area where the hob
sits must be completely filled with grout.
• Ensure that the seal is correctly seated against the work
surface without any gaps. Additional silicon sealant must not
be applied; this would make removal more difficult when
servicing.
• The hob must be pressed out from below when removed.
• A board is to be installed underneath the hob.
• The ventilation gap between the worktop and front of the unit
underneath it must not be covered.
English - 12