Installation; Installing The Monitor - Alpine TME-M790 Owner's Manual

Installation and Connections

Installation

Installing the Monitor

• Place of installation
Before determining the position of installation,
check that the display will not hamper gear
shifting when it is opened and closed in that
position.
NOTE
Install at an angle of within 30 degress from the
horizontal.
1
Mounting Sleeve
(Included)
Screws(M4x5)
(Included)
Slide mounting sleeve from main unit (see
Removal Procedure below). Slide the mounting
sleeve into the dashboard. Install the supplied
bracket to the monitor.
2
Screw
Hex Nut
(M5)
Ground Lead
Chassis
Reinforce the monitor with the metal mounting
strap (not supplied). Secure the ground lead of
the unit to a clean metal spot using a screw ( )
already attached to the vehicle's chassis.
NOTE
For the screw marked
screw for the chosen mounting location.
16
-EN
Dashboard
Mounting Bracket
(Included)
TME-M790
Metal Mounting Strap
Bolt Stud
TME-M790
Front Frame
(Included)
, use an appropriate
3
Slide the TME-M790 into the dashboard. When
the unit is in place, make sure the locking pins
are fully seated in the down position. This can be
done by pressing firmly in on the unit while
pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly
locked and will not accidentally come out from
the dashboard. Install the Supplied Front Frame.
Removal
1 Use a small screwdriver (or similar tool) to
push the locking pins to the "up" position (see
above drawing). As each pin is unlocked,
gently pull out on the unit to make sure it does
not re-lock before unlocking the second pin.
2 Pull the unit out, keeping it unlocked as you do
so.
<JAPANESE CAR>
To install using the vehicle's genuine bracket
TME-M790
Ground Lead
Mounting Bracket
Lock Pin
Screws
(M4x5)