Alesis 03D Owner's Manual page 262

252
Symptom
Configured a stereo pair but the
signal appears to be in mono!
Configured a stereo pair but the
signal sounds out of phase!
Signals appeared to be delayed!
Added faders to a fader group but
grouping does not work!
Added channels to a mute group but
group muting does not work!
Cannot recall effects programs 43, or
64 to Effect 1!
Cannot access the Bus To ST page!
Cannot recall a channel program!
Cannot store a mix scene!
Recalling a mix scene doesn't update
some channels!
Cannot recall mix scenes using MIDI
Program Change messages!
Cannot control mix parameters using
MIDI Control Change messages!
Automix cannot record!
Some channels do not respond to
automix recording and playback!
Fader movement is not consistent!
03D—Owner's Manual
Make sure that the odd channel is panned hard left, and the right
channel is panned hard right.
Make sure that the phase of both input channels in the stereo pair is set
the same. Phase settings are not linked when channels are configured
as a stereo pair. See Phase on page 39 for more information.
Make sure that the Channel Delay function is set correctly. See Channel
Delay on page 40 for more information.
Make sure that the fader group is enabled. See Fader Groups on page
112 for more information.
Make sure that the mute group is enabled. See Mute Groups on page
113 for more information.
These effects programs use the HQ. PITCH and FREEZE type effects,
and can be recalled only to Effect 2.
Make sure the Pan mode is set to Stereo. When a surround pan mode is
selected this page cannot be accessed. See Selecting a Pan Mode on
page 58 for more information.
Does the program contain data that corresponds to the selected chan-
nel? See Recalling Channel Programs on page 106 for more informa-
tion.
Is the selected scene memory protected? See Write Protecting Scene
Memories on page 170 for more information.
Are those channels set as safe channels? See Recalling Scene Data
Safely on page 174 for more information.
Make sure that the 03D is configured to receive Program Change mes-
sages and the MIDI Channels match. See MIDI Setup on page 235 for
more information.
Check the mix scene to Program Change assign table. See Program
Change Assign on page 239 for more information.
Make sure that the 03D is configured to receive Control Change mes-
sages and that the MIDI Channels match. See MIDI Setup on page 235
for more information.
Check the parameter to Control Change assign table. See Control
Change Assign on page 240 for more information.
Make sure that the Automix function is enabled. See Enabling Automix
on page 180 for more information.
Are these channels set as safe channels? See Safe Channels on page
183 for more information.
Calibrate the faders. See Calibrating the Faders on page 214 for more
information.
Advice