Getting Started; Use The Lcd Menu - Grandstream Networks UCM630X Series User Manual

GETTING STARTED

To get started with the UCM630X setup process, use the following available interfaces: LCD display, and web
portal.
•
The LCD display shows hardware, software, interface status, and network information and can be navigated
via the Slide control and Touch keys. From here, users can configure basic network settings, run diagnostic
tests, and factory reset.
•
The web portal (may also be referred to as web UI in this guide) is the primary method of configuring the
UCM.
This section will provide step-by-step instructions on how to use these interfaces to quickly set up the UCM and
start making and receiving calls with it.

Use the LCD Menu

•
Idle Screen
Once the device has booted up completely, the LCD will show the UCM model, hardware version, and IP
address. Upon menu key press timeout (30 seconds), the screen will default back to this information.
•
Menu
Pressing the Home button will show the main menu. All available menu options are found in [Table 3: LCD
Menu Options].
•
Menu Navigation
Scrolling down using slide control through the menu options. Press the OK button to select an option.
•
Exit
Selecting the Back option will return to the previous menu. For the Device Info, Network Info, and Web Info
screens that have no Back option, pressing the OK button will return to the previous menu.
•
LCD Backlight
The LCD backlight will turn on upon button press and will go off when idle for 30 seconds.
The following table summarizes the layout of the LCD menu of UCM630x.
UCM630X Series User Manual
Version 1.0.11.10
P a g e | 60