Fcc Radio Frequency Emission; Fcc Notice - Samsung Galaxy Tab SPH-P100 User Manual

SAR tests are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands. Although the
SAR is determined at the highest certified power level, the
actual SAR level of the device while operating can be well
below the maximum value. This is because the device is
designed to operate at multiple power levels so as to use only
the power required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power
output.
Before a new model device is available for sale to the public, it
must be tested and certified to the FCC that it does not exceed
the exposure limit established by the FCC. Tests for each
model of a device are performed in positions and locations
(e.g. near the body) as required by the FCC.
For typical operations, this device has been tested and meets
FCC RF exposure guidelines.
Use of other accessories may not ensure compliance with FCC
RF exposure guidelines.
The FCC has granted an Equipment Authorization for this
device with all reported SAR levels evaluated as in compliance
with the FCC RF exposure guidelines. The maximum SAR
value for this model phone as reported to the FCC is:
Cellular CDMA mode (Part 22)
Body-worn: 0.98 W/kg
:
:
PCS mode (Part 24)
Body-worn: 1.19 W/kg
WLAN (2.4G) :
Body-worn: 0.54 W/kg

FCC Radio Frequency Emission

This device meets the FCC Radio Frequency Emission
Guidelines.
SAR information on this and other model devices can be
viewed online at
http://ww.fcc.gov/oet/ea . To find information that pertains to this
particular model device, this site uses the FCC ID number
A3LSPHP100. This number can be confirmed by looking on
the rear case of your device.
Follow the instructions on the website and it should provide
values for typical or maximum SAR for a particular device.
Additional product specific SAR information can also be
obtained at www.fcc.gov/cgb/sar .

FCC Notice

This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
4A. Important Safety Information 195