Table of Contents
Advertisement
SETTING UP THE MASSAGE LOUNGER
1. Where to use the unit
•
Ensure there is adequate space to recline.
•
Do not expose the massage lounger to direct sunlight or high
temperatures, such as in front of heating sources, because this can
cause discoloration or hardening of the synthetic leather.
•
Place the unit on a mat to prevent floor damage.
•
When placing a mat under the unit, the size of the mat should be
sufficient [at least 47.2 in. × 27.6 in. (120 cm × 70 cm)] to cover the
areas where the unit touches and where the legrest could touch the
floor, as shown in the diagram on the right.
•
Install the unit near a power outlet.
See Warning No. 11 and 12 on page 1.
2. Removing everything from the box and installing the unit
Fabric
Section
Hold the cloth
section on the
backside
Legrest
9
Groove
Place your
fingers in the
groove
Back cover
Mat
Keep at least 4" (10 cm) away from the wall.
Approx. 71.3 in. (181 cm)
Width approx.
32.3 in. (82 cm)
Approx.
9.8 in. (25 cm)
Mat
Area where legrest
could touch the floor
•
Since the unit is very heavy [approximately 144 lbs
(65 kg)], be careful to avoid back injuries. (The unit
must be carried by two persons.)
•
When using the wheels to move the unit, place a mat
on the floor to protect the floor surface.
To put the unit down on the floor
•
Put the unit down slowly and carefully watch your step.
•
Put down the legrest by holding it with your hands until
it has been set on the floor completely. If you release
your hands before the legrest is fully extended, the
legrest will forcefully return to the initial position.
Approx.
12.6 in. (32 cm)
Area where unit
touches the floor
Hide quick links:
Advertisement
Table of Contents
