To Sanitise With Your Steam Mop - Shark S1000ANZ Owner's Manual

USING YOUR STEAM MOP - CONT.
1
Pull and twist the quick release cord holder to
unwrap the power cord completely (Fig� 1)� When
Steam Mop is plugged into an electrical socket,
the power light will illuminate (Fig� 2)� It takes
approximately 30 seconds for the mop to heat up
and the steam to be ready�
2 Pump the handle a few times in a downward
motion (Fig� 3) This pumping action will release
steam as you mop and allows you to customise the
amount of steam you want� Begin mopping with a
forward and backward motion� The natural motion
of mopping will produce steam�
3 When the water tank is empty, the Steam Mop will
stop producing steam� Make sure to unplug the
Steam Mop before refilling the water tank� Follow
the water tank refilling instructions on pages 7-8�
9
AUS 1800 099 385 or NZ 0800 112 660
Fig. 1
Fig. 3
Fig. 2
TO SANITISE* WITH YOUR STEAM MOP
1 Start with a clean pad�
2 Pump the handle a few times in a downward motion (Fig� 1)�
3 Start mopping on an appropriate sealed hard-floor surface with a forward and
backward motion� After three minutes, your unit is ready to be used to sanitise�
4 Using a forward and backward motion, move the unit over the area you seek to
sanitise� Repeat at least 15 times�
*Sanitisation studies were conducted under controlled test
conditions� Household conditions and results may vary�
Fig. 1
s h a r kc l e a n . c o m . a u o r s h a r kc l e a n . c o . n z
10