Getting Started With Your Steam Mop - Shark S3901UKL Owner's Manual

Getting Started with Your Steam Mop

fig. 1
IMPORTANT: Always make sure the mop is
UNPLUGGED from the wall when not in use.
Never fill the mop, attach the mop head, change
or remove the cleaning pocket when the mop is
plugged into the wall. To prolong the life of your
Shark ® Lift-Away ™ Pro Steam Pocket
Mop we recommend using distilled water. Make
sure you only add water to the tank. Chemicals
or cleaning solution may damage the appliance
and could be unsafe for you and your family.
4 www.lakeland.co.uk
fig. 2
STEAM MOP ASSEMBLY
1
Insert the Mop Handle end labeled "Front" into
the Steam Mop Housing. Make sure it is inserted
past the line printed on the pole. Secure the
assembled handle and pole by using the large
®
screw and a Phillips or a flat head screw driver
(screwdriver not included). (fig. 1)
2 Insert the Handheld Steamer into the Steam Mop
Housing. (fig. 2)
fig. 3
fig. 4
3 Use the loop on the side of the cleaning pocket
to slide the mop head into the pad pocket. Then
secure the quick fasteners on the top of the
pocket to lock in place. (fig. 3)
4 Snap the mop head into the mop body by lining
up the groove on the back of the mop body with
the groove on the back of the mop head. Push
until you hear it latch into place. (fig. 4)
5
Turn the water tank cap counter clockwise and
remove from the tank. (fig. 5)
Use the filling flask and pour water into the tank.
Do not overfill. Replace the cap on the water
tank. (fig. 6)
fig. 5
fig. 6
IMPORTANT: Do not use on unsealed wood
or unglazed ceramic floors. On surfaces that
have been treated with wax or some no wax
floors, the sheen may be removed by the heat
and steam action. It is always recommended to
test an isolated area of the surface to be cleaned
before proceeding. We recommend that you
check the use and care instructions from the
floor manufacturer.
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
www.lakeland.co.uk 5