Table of Contents
Advertisement
User's Guide
Installation
Installation
You can make the 16442A stable by installing stabilizers as shown in the following
figure.
1. Put a stabilizer on both sides of test fixture.
2. Screw a flathead screw into hole of each stabilizer.
After installing stabilizers, connect terminals on the rear panel to the desired
measurement units.
NOTE
When you attach the 16442A to Agilent 16440A SMU/Pulse Generator Selector or
Agilent 16441A R-Box, you do not need to install stabilizers. For attaching to
selector or R-Box procedure, see the User's Guide for selector or R-Box.
12
Agilent 16442A User's Guide, Edition 3
Advertisement
Table of Contents
