Troubleshooting; Warranty; Ce Declaration Of Conformity; Environmentally-Friendly Disposal - Cub Cadet L20 Manual

EN
Risk of injuries or material damage
¾ In case of doubt always consult a service centre.
¾ Before any inspection or any work on the device, switch off the motor and remove the power
pack.
Problem Possible cause
The device switch- The power pack is too hot.
es off.
The power pack is discharged.
The temperature of the device (electronics) is
too high.
Overcurrent release
The device will not The power pack is discharged.
switch on.
Overvoltage release
Overcurrent release
Power pack temperature too high or too low.
The power pack is defective.
Line readjustment The spool is empty.
does not work
The toothing between the spool housing and the
while the trimmer is
line spool is dirty.
running.
The line has torn off and is pulled into the line
spool. The line has become caught in the spool.
The line is welded onto the spool.
Strong vibrations Device fastening elements have become loose. Consult a specialist workshop.

Warranty

The warranty conditions of our local company or
importer apply in all countries. Under the terms of
the warranty we will repair faults on your device
free of charge, insofar as material or manufactu-
ring defects are the cause. To make a claim under
warranty please contact your seller or your nearest
branch.

CE Declaration of Conformity

Further details about the device are con-
tained on the separately enclosed CE Decla-
ration of Conformity, which forms part of this
instruction manual.
26

Troubleshooting

WARNING!

Environmentally-friendly disposal

Electrical tools, accessories and packaging must be
routed into an environmentally compatible recycling
chain.
Power packs/batteries:
Do not dispose of power packs/batteries
in domestic waste, by burning or throwing
into water. Power packs/batteries must be
collected, recycled or disposed of in an
environmentally-friendly manner.
Power tools:
Do not throw your old power tool away with the
domestic waste. Take it to a disposal facility.
Remedy
Allow the power pack to cool.
Charge the power pack.
Allow the device to cool and if necessary,
clean the ventilation slots
If this occurs again take your device to a
specialist workshop.
Charge the power pack.
If this occurs again take your device to a
specialist workshop.
If this occurs again take your device to a
specialist workshop.
Allow the power pack to cool down or
heat up.
Replace the power pack.
Wind on a new cutting line.
Use a brush to remove dirt from the parts.
Remove the line spool and remove the
line from the spool. Refit the spool and
rewind the cutting line on it.
Remove the line and rewind the line.
Troubleshooting