Weider 2250 User Manual page 11

10. Route the Short Cable (58) around the 90mm
Pulley (15). Tighten the M10 x 80mm Bolt (16),
the M10 Washer (9), and the M10 Nylon Locknut
(21).
11. Route the Short Cable (58) under a 90mm Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the upper hole in the Front Upright (42) with an
M10 x 95mm Bolt (71), an M10 Washer (9), and
an M10 Nylon Locknut (21). Make sure that the
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
12. Attach the end of the Short Cable (58) to the
Long "U"-bracket (57) with an M8 Nylon Locknut
(3) and an M8 Washer (8). See the inset draw-
ing. Do not overtighten the Nylon Locknut; it
should be threaded onto the end of the Cable
so that two threads are showing above the
Nylon Locknut.
13. Locate the Long Cable (23). Route the Long
Cable over a 90mm Pulley (15). Make sure that
the Cable is between the Pulley and the hook,
and that the end of the Cable with the ball is
on the indicated side of the hook. Attach the
Pulley with an M10 x 90mm Bolt (85) and an M10
Nylon Locknut (21).
All manuals and user guides at all-guides.com
11
10
21
15
58
11
21
12
57
3
8
58
13
21
Hook
15
23
Ball
9
16
42
9
58
15 66
71
3
8
57
58
85