Table of Contents
Advertisement
The operating instructions mentioned here are partial abstracts
from the Operating Instruction Manual. The page numbers of
the Operating Instruction Manual remain as in the manual.
Installing an ergonomic video workstation
Before you set up your equipment you should select a suitable position for working at the monitor.
Please observe the following advices when installing a video workstation.
Avoid direct and reflected glare.
Avoid glare from electric
lighting.
preferable viewing sector
65°
0°
30°
60°
30°
permissible
65°
viewing sector
permissible viewing sector
Position the monitor for
Keep ventilated areas clear.
optimum viewing. The viewing
distance to the monitor should
be approximately 50 cm.
Connecting the monitor
See your PC's operating manual for details of the ports on the system unit.
!
Please note the information provided in the "Safety" section in the chapter "Important
notes" at the beginning of this manual.
Do not cover the ventilation openings of the monitor.
If you are assembling monitors beside each other, there must be a minimum distance of
30 cm between monitors of the same constructional type, to avoid image distortion. With
different monitors, the distance must be increased, if necessary.
A26361-K616-Z100-1-5E19
SECTION 1
GENERAL
Color monitor 19T2
edge of desk
permissible
permissible
reaching sector
reaching sector
600 mm
600 mm
Position the keyboard where it
is easiest to reach.
approx. 90°
approx. 90°
and
more
Remember to maintain correct
posture.
English - 7
Color monitor 19T2
1
2
1 = Power connector
2 = Data cable
Be sure that the monitor and the system unit are switched off.
!
The system unit's power plug must be pulled out!
Connect the connector of the data cable to the (active) monitor port on the system unit and
secure the plug-in connection by tightening the safety screws.
If your system unit has two monitor ports ("onboard" screen controller and separate
i
graphics card), the monitor port for the separate graphics card is usually active.
Plug the power cable supplied into the power connector (1) of the monitor.
Plug the power connector of the monitor into a properly grounded power outlet.
Plug the power connector of the system unit into a properly grounded power outlet.
When you start working with your monitor for the first time you should install the
i
appropriate graphics drivers for your application software. Details of how to do this are
provided in the documentation on your screen controller/the associated driver software.
8 - English
A26361-K616-Z100-1-5E19
Advertisement
Table of Contents
