Siemens 19T2 Service Manual page 8

Operating the OSD menu
To set the OSD menu, perform the following steps:


Briefly press the Menu button to activate the OSD menu.
The main menu appears on the screen with icons for the setting functions.
MENU OK
EXIT
SIZE/CENTER
GEOMETRY
COLOR
CONVERGENCE
LANGUAGE
A
OPTION
HELP
?
Depending on what options window is involved (here: GEOMETRY.), further icons are offered.


GEOMETRY


All changes are stored automatically.
The OSD menu disappears after approx.
30 seconds. The OSD menu can be hidden
beforehand by pressing the menu button
(possibly several times).
26
Adjusting the contrast and brightness
The contrast and brightness can be adjusted directly with the arrow buttons
the control panel when the OSD menu is hidden. The set values are saved for all input signals.
You will increase the life of your screen if you adjust the contrast and brightness to
i
medium.
In the setting window for contrast and brightness, the horizontal frequency and refresh
rate of the current input signal are displayed as additional information.
A26361-K616-Z100-1-5E19
Color monitor 19T2


Select the desired symbol with the arrow
buttons and , e. g.
GEOMETRY.
(If you wish to exit the OSD menu, select
EXIT.)
The selected symbol has a colored
marking.


Press the Menu button to display the
appropriate options window.
If necessary, select a different symbol with
the arrow buttons .
Make the required setting using the arrow
buttons .
and of
English - 11
Color monitor 19T2
Setting the brightness of the background
Setting the contrast between the foreground and background
Setting picture position and size (SIZE/CENTER)
The set values for the picture position and size are only saved for the current input signal.
Calling the SIZE/CENTER setting window
Horizontal picture position (H CENTER): Shifting the picture to the left or to the
right
Vertical picture position (V CENTER): Shifting the picture down or up
Horizontal picture size (H SIZE): Making the picture narrower or wider
Vertical picture size (V SIZE): Making the picture shorter or longer
Proportional picture size (ZOOM): Increasing or reducing picture size while
retaining the side ratios
The picture zoom adjustment will stop as soon as either the horizontal or vertical
size reaches its maximum or minimum value.
Setting the picture geometry (GEOMETRY)
Tilt distortion must be set when the screen display is not axially symmetrical.
Pincushion distortion is when the sides of the screen display are bent inward or outward. Trapezoid
distortion is when the top or bottom of the screen display is too wide or too narrow. Parallelogram
distortion means that the sides of the picture bend to the left or right.
The set value for the picture rotation is saved for all input signals. All other values of the picture
geometry are only saved for the current input signal.
Calling the GEOMETRY options window
Picture rotation (ROTATION): Rotating the picture in a clockwise or counter-
clockwise direction
Vertical pincushion distortion (PINCUSHION): Bending the right and left side
inward or outward
Asymmetrical pincushion distortion (PIN BALANCE): adjusting right and left side
symmetrically
12 - English
A26361-K616-Z100-1-5E19