Mitsubishi Electric MSZ-D30NA Service Manual page 35

Fixing the indoor coil thermistor
* There are 2 forms of parts for fixing the indoor coil thermistor.
Clip shape
Position and procedure for mounting the clip-shape part
1. Set the indoor coil
thermistor in the center
of the clip-shape part.
NOTE:
Take care to avoid loss and accidental falling of the clip-shape part inside the unit.
Mount the clip-shape part on the marked position.
Do not pull the lead wire when removing the indoor coil thermistor.
OBH501D
Holder shape
2. Check the (marked)
mounting position.
35
When fixing the indoor coil thermistor
to the clip-shape/holder-shape part,
the lead wire should point down.
About the
same length
3. Mount the
clip-shape part.