Mitsubishi Electric MSZ-D30NA Service Manual page 34

OPERATING PROCEDURE
6. Removing the line flow fan and the indoor fan motor
(1) Remove the panel and the corner box. (Refer to section 1.)
(2) Remove the electrical box. (Refer to section 2.)
(3) Remove the nozzle assembly. (Refer to section 3.)
(4) Remove the water cover.
(5) Loosen the screw of the line flow fan.
(6) Remove the screws of the motor bed.
(7) Remove the lead wire of the indoor coil thermistor from the
hooks of the motor bed.
(8) Remove the motor band and the motor bed together with
indoor fan motor. (Be careful not to drop the indoor fan
motor because it is heavy.)
(9) Remove the screw of the motor band, and remove the
motor band then pull out the indoor fan motor.
(10) Remove the screws of the left side of the heat exchanger.
(11) Lift the left side of the heat exchanger.
(12) Remove the line flow fan to the lower-left.
Photo 9
OBH501D
Photo 7
Photo 8
Screws of the left
side of the heat
exchanger
Screw of the
line flow fan
34
PHOTOS/FIGURES
Screw of the motor band
Screws of the motor bed
Lead wire of the indoor
coil thermistor