Complete The Installation - Kohler K-11344 Installation And Care Manual

x4
7. Secure the Bath
Turn the bath shell upside down on the saw horses.
Make sure all the drain connections are secure.
Position the shroud on the bath so the edges of the shroud rest inside the bath shell.
Secure the shroud to the bath with a screw at each corner. Do not overtighten.
Make sure the foot clips are not in the locked position.
Carefully lift the bath into position so the posts on the bath frame fit into the four foot clips, and the
drain tailpiece fits into the drain pipe.
Check for solid fit (no rocking) and a 24-1/8" (613 mm) rim corner height to the finished floor.
Lift and move the bath if needed, and adjust the four posts as needed to ensure a distance of
24-1/8" (613 mm) from the finished floor to the top of each bath rim corner. Adjust the bath levelers
as needed. Make sure the bath levelers and bath feet are tight.
Press down on the bath corners with your hand to make sure the bath does not move up and down,
or side to side. If the bath moves check that all four posts are inside the foot clips, and check that
the floor is level.
Use a flat-bladed screwdriver to push in the four locking plates to lock the bath feet in place.

8. Complete the Installation

Secure the drain tailpiece to the drain pipe.
Install the bath faucet according to the instructions included with the faucet.
Run water into the bath and check the drain connections for leakage.
1207307-2-B
24-1/8"
(613 mm)
8
x4
x4
Post
x2
Bath
Leveler
Kohler Co.