Start Up; Shut Down; Preparing The Icemaker For Long Storage; Maintenance - Hoshizaki FM-120KE-N Instruction Manual

Self-contained
Hide thumbs Also See for FM-120KE-N:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
This icemaker is designed to produce edible ice. To keep the icemaker hygienic:
* Wash your hands before removing ice. Use the plastic scoop provided (accessory).
* The storage bin is for ice use only. Do not store anything else in the bin nor use other electrical appliances in the bin.
* Clean the storage bin before use (see "III. 1. CLEANING").
* Keep the scoop clean. Clean it by using a neutral cleaner and rinse thoroughly.
* Close the door after removing ice to prevent entrance of dirt, dust or insects into the storage bin.

1. START UP

The installer will normally commission the icemaker to start the
automatic icemaking process. To ensure continuous operation, make
sure that:
* The water supply tap is on, and
* The icemaker is connected to the power supply.
To start the icemaking process, check the position of the operation
switch on the operation panel:
"OFF" position - Move it to the "ON" position.
"ON" position - Press the ice button.

2. SHUT DOWN

Press the stop button on the operation panel. The "STOP" and "DRAIN"
modes light up on the display. Then, only the "DRAIN" mode goes off.

3. PREPARING THE ICEMAKER FOR LONG STORAGE

This icemaker will not work at subfreezing temperatures. To prevent damage to the water supply line, drain the icemaker when
air temperature is below zero.
When shutting down the icemaker for two or more days, drain the icemaker to prevent contamination in the water circuit.
1) Follow the instructions in "2. SHUT DOWN".
2) Move the operation switch to the "OFF" position.
3) Close the water supply tap.
4) Remove the inlet hose from the water supply tap, and drain the hose.
5) Disconnect the power supply.
6) Remove all ice from the storage bin, and clean the bin.
7) Ask for draining of the icemaker by professional qualified personnel.
8) To restart the icemaker, follow the instructions in "1. START UP".
III. MAINTENANCE

1. CLEANING

Before carrying out any cleaning or maintenance operations, unplug the icemaker from the electrical supply network.
This appliance must not be cleaned by use of a water jet.
HYGIENE
Ice Button
Maintenance Button
(service use only)
NOTICE
HYGIENE
WARNING
5
ENGLISH
Operation Panel
Display
Stop Button
Operation Switch

Advertisement

Table of Contents
loading

Table of Contents