Setting The Speakers - Sony STR-DA5600ES Operating Instructions Manual

The receiver will be rebooted. When the
lamp above ?/1 flashes in green, the reboot
is complete.
Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the RM-
AAL031 or RM-AAL032 remote commander,
and the RM-AAU061 remote commander.
Observe the correct polarity when installing
batteries.
RM-AAL031
RM-AAL032
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the programmed
remote codes may be cleared. If this happens,
program the remote codes again (page 153).
Tip
When the remote no longer operates the receiver,
replace all the batteries with new ones.
44
GB
RM-AAU061

9: Setting the speakers

Setting the speaker impedances
Set the appropriate speaker impedance for the
speakers you are using.
1
Press MENU.
The menu is displayed on the TV screen.
2
Press V/v repeatedly to select
" Settings," then press
b.
The Settings menu list appears on the TV
screen.
3
Press V/v repeatedly to select
"Speaker," then press
V/v/b,
MENU
or
or b.