Nokia RM-59 User Manual page 67

1. In the standby mode, select Menu
2. Enter your lock code, and select OK. See "Change lock code," p. 76.
3. Select your desired calling card.
4. Press the end key to return to the standby mode; then enter the phone
number, including any prefix (such as 0 or 1) that your calling card may
require when you make a calling card call. See your calling card for
instructions
5. Press and hold the call key for a few seconds until
6. When you hear the tone or system message, select OK.
Data or fax calls
Data and fax calling is a network service. See "Network services," p. 7. If your
network operator supports this feature, you can set up the device to send or
receive data and fax calls with a terminal, such as a PDA or PC, connected.
For better performance during data calls, place the device on a stationary
surface. Do not move the device or hold it in your hand during a data call.
For more information on connectivity, refer to the PC/PDA Connectivity Guide
which can be downloaded from the Nokia website at http://www.nokia.com/us.
1. In the standby mode, select Menu
Incoming data/fax call and one of the following options:
Normal—The device receives incoming calls as usual.
Data calls only—The device receives only data calls.
Fax calls only—The device receives only fax calls.
2. When finished with receiving the fax or data call, repeat steps 1 and 2, and
select Normal.
Data transfer
You can view the transmission speed when sending or receiving data and fax
calls. In the standby mode, select
rate display > Graphic or Off.
Call summary
Your device can display the time spent on a call when you hang up. In the standby
mode, select Menu > Settings >
FCC DRAFT
> Settings > Call > Calling
Card call is displayed.
> Settings > Call > Data/fax calls
Menu > Settings > Call > Data/fax calls
Call > Call summary > On or Off.
S e t t i n g s
card.
>
> Data
69