Pre-Installation Requirements; Tool Requirements - Frigidaire FLCG7522AW Use & Care Manual

PRE-INSTALLATION REQUIREMENTS

Shipping hardware
‰ Foam shipping restraint (inside
wash tub) removed and stored
‰ Foam shipping support (underneath
appliance) removed and stored
Leveling
‰ Laundry center is level, side-to-side
and front-to-back
‰ Cabinet is sitting solid on all corners
Water supply
‰ Use only new hoses and verify
rubber sealing washers are installed
‰ HOT supply is connected to HOT
inlet and COLD supply is connected
to COLD inlet
‰ HOT and COLD water supply turned on
‰ No leaks present at water supply
connections or appliance inlet
connections-recheck after 24 hours
Drain
‰ Stand pipe or wall drain height min. 33"
‰ Drain hose secured in place with
cable tie (shipped in drum)
Exhaust venting
‰ Free-flowing, clear of lint buildup
‰ 4 inch (102 mm) rigid or semi-rigid
ducting of minimal length and turns
‰ NO foil or plastic venting material
‰ Approved vent hood exhausted to
outdoors

Tool requirements

Tools and materials needed for installation:
• Adjustable pliers
• Phillips, straight, & square bit
screwdrivers
• Adjustable wrench
• Pipe wrench for gas supply (gas dryer)
• LP-resistant thread tape (for natural
gas or LP supply, gas dryer)
• Carpenter's level
• External vent hood
• 4-inch (102 mm), rigid metal or semi-
rigid metal exhaust duct work
• 3-wire or 4-wire 240 volt cord kit
(electric dryer)

Installation Checklist
Gas supply (Gas Dryer)
‰ Manual shutoff valve present in supply
‰ All connections sealed with
approved sealer and wrench tight
‰ Conversion kit for LP system
(*P/N 5304523143 not included)
‰ Gas supply turned on
‰ No leaks present at all connections -
check with soapy water, NEVER
check with flame
208v/240V electric supply
(electric dryer)
‰ Approved NEMA 10-30 or 14-30
service cord with all screws tight on
terminal block
‰ Approved strain relief installed
‰ Terminal access cover installed
before initial operation
Electrical power
‰ House power turned on
‰ Laundry Center plugged in
Final checks
‰ Installation Instructions and Use &
Care Guide read thoroughly
‰ Water enters drum when cycle
starts with lid lowered
‰ Dryer door latches and drum
tumbles when cycle starts
‰ Registration card sent in
• 4 in. (102 mm) clamp
• Gas line shutoff valve (gas dryer)
• 1/2 NPT union flare adapters (x2) and
flexible gas supply line (gas dryer)
• Metal foil tape (not duct tape)
• Inlet hoses (x2)

NOTE
Hoses are not included with washer
purchase.
9