Table of Contents
Advertisement
26
INSTALLATION
Cable Tie
NOTE
The standpipe inside diameter must be
1-1/4" (3.2 cm) minimum. There must be
an air gap around the drain hose in the
standpipe. A snug hose fit can cause a
siphoning action.
Completing the installation
IMPORTANT
Check to ensure the power is off at
a circuit breaker/fuse box before
plugging the power cord into an outlet.
1.
Plug the power cord into a grounded
outlet.
WARNING
Improper grounding of the dryer may
cause serious injury or death. Check
with a licensed electrician if you are in
doubt as to whether the appliance is
properly grounded.
Insert Less
Than 8.5"
(21.5 cm)
Grounding type wall receptacle
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.
Power cord with
3-prong grounded plug
2. Turn on the power at the circuit
breaker/fuse box.
3. Run the washer through a complete
cycle, checking for water leaks and
proper operation.
4. If you have any questions during
initial operation, please review
Troubleshooting before calling for
service.
5. Place these instructions in a location
near the appliance for future
reference.
NOTE
A wiring diagram and technical data
sheet are located behind the dryer
access panel.
WARNING
When discarding or storing your old
laundry center, ALWAYS remove the
washer and dryer doors.
Hide quick links:
Advertisement
Table of Contents
