Part
Pump-Drain
Sensor-Turbidity
※ Reassembly is in the reverse order of the removal.
24 _ Disassembly and Reassembly
Figure
Preparation:
•
1.
2. Disconnect the two(2) Pump-drain connectors.
Preparation:
•
1. Remove the sensor-turbidity connector.
2. Remove the two hooks from the sensor-turbidity.
Description
Disassemble the shutter.
- Refer the "Cover base" disassembly section.
R emove the Pump-drain by rotating it
counterclockwise lifting up the hook holding it in
place slightly.
C aution
M ake sure to remove remain water in the
dishwasher. If not, water will spill on to the floor.
:
T he Pump-drain has a seal .
Disassemble the cover base.
- Refer the "Cover base" disassembly section.
C aution
Use a flat screwdriver carefully to remove it from
the Assy sump preventing breakage.
: T he sensor-turbidity has a seal .