5.5.5
Installing mounting plate on the mast
Procedure
Figure 5-11
Follow the steps below to fit the holding plate to a mast:
1. Guide the hose clips through the slots of the holding plate (position A in the figure above).
2. Place the hose clips at the required position round the mast.
3. Place the free end of a hose clip through the quick release fastener. You can swivel the
clamping screw (position B in the figure above) to the side to adapt the diameter of the hose
clip to the mast diameter. The minimum mast diameter is 44 mm and the maximum mast
diameter is 178 mm.
4. Press the clamping screw against the securing strap and tighten the clamping screw,
tightening torque 4.5 Nm.
SCALANCE W786-x
Operating Instructions, 12/2021, A5E03678337-14
B
Holding plate with hose clips for mast mounting
A
Installation and removal
5.5 Mounting with mounting plate
43