Care Of Glass; Care Of Plated Parts - Napoleon 1400ML Installation And Operating Instructions Manual

30
To reinstall the secondary air manifold follow these
instructions:
Locate the slot at the front of the firebox chamber, as
A.
illustrated.
EN
Insert the tab of the secondary air manifold into the
B.
above mentioned slot and pivot the secondary air
manifold into position.
A new gasket MUST be installed between the
C.
secondary air manifold and firebox.
Insert one of the bolts to hold the secondary air manifold
D.
in place.
E. Working from the inside of the firebox, take the second
bolt and install it into position, loosely secure the washer and nut.
Remove the first bolt and reinstall as previously described in step E. Fully tighten both nuts and bolts.
F.
Reinstall the baffles and bricks.
G.
To reinstall the rear and side shields, refer to steps A and B of the removal instructions.
H.
NOTE: PUSH THE BAFFLE ALL THE WAY TO THE REAR OF THE FIREBOX, LEAVING A MINIMUM
OF 1" (25mm) GAP ALONG THE FRONT. THIS WILL ALLOW FLUE GASES TO PROPERLY ESCAPE THE
FIREBOX.
8.8

CARE OF GLASS

If the glass is not kept clean permanent discolouration and / or
blemishes may result. Normally a hot fi re will clean the glass.
The most common reasons for dirty glass include: not using
suffi cient fuel to get the appliance thoroughly hot, using green
or wet wood, closing the draft so far that there is insuffi cient air
for complete combustion.
If it is necessary to clean the glass, buff lightly with a clean dry
cloth and non-abrasive cleaner.
DO NOT CLEAN GLASS WHEN HOT! Clean the glass after the fi rst 10 hours of operation with a
recommended appliance glass cleaner. Thereafter clean as required.
The glass is very strong but do not let burning fuel rest or fall against it and always close the door gently.
NEVER FORCE IT SHUT!
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out and do
not operate the appliance again until the glass has been replaced. Available from your Authorized dealer.
DO NOT SUBSTITUTE MATERIALS.
This appliance is factory equipped with 5mm ceramic glass. Use only replacement parts as supplied by the
appliance manufacturer. DO NOT SUBSTITUTE MATERIALS.
8.9

CARE OF PLATED PARTS

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on the
plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room temperature
but this can be improved if the assembly is warmed, using a hair dryer or similar heat source.
W415-1467 / C / 08.20.18
SIDE VIEW
SECONDARY AIR MANIFOLD
SLOT
AIRWASH
SHEILD
AND
GASKET
WARNING
!
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
AVERTISSEMENT
!
LA VITRE CHAUDE CAUSERA
NE PAS TOUCHER LA VITRE
AVANT QU'ELLE AIT REFROIDI.
NE JAMAIS LAISSER LES
ENFANTS TOUCHER LA VITRE.
5.3
5.5.1A
6.1
NUT AND
BOLT(x2)
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
DES BRÛLURES.