Watching Tv - Sony KDF-50E2000 Operating Instructions Manual

Watching TV

Watching TV
T IM E R L A M P P O W E R /S T A N D B Y P O W E R
P U S H O P E N
W E G A G A T E
T V /V ID E O VO L U M E C A N N E L
1
2
1
Press 1 on the TV (front side) to switch on
the TV.
When the TV is in standby mode (the 1 (standby)
indicator on the TV (front) is red), press "/1 on
the remote to switch on the TV.
2
Press DIGITAL to switch to digital mode or
ANALOG to switch to analogue mode.
The channels available vary depending on the
mode.
3
2
3
Additional operations
To
3
Turn off the TV
temporarily
(Standby mode)
Turn on the TV
from Standby mode
without sound
Switch off the TV.
Note
To disconnect the TV completely, pull the plug from the
mains.
Adjust the volume
Mute the sound
Access the
Programme index
table (in analogue
mode only)
Press the number buttons or PROG +/- to
select a TV channel.
To select channel numbers 10 and above using the
number buttons, enter the second and third digits
within two seconds.
To select a digital channel using the Digital
Electronic Programme Guide (EPG), see page 15.
In digital mode
An information banner appears briefly. The
following icons may be indicated on the banner.
: Interactive service is available (MHEG Digital
Text)
: Interactive service (MHEG Digital Text) is
currently disabled
: Radio service
: Scrambled/Subscription service
: Multiple audio languages available
: Subtitles available
: Subtitles available for the hearing impaired
: Recommended minimum age for current
programme (from 4 to 18 years)
: Parental Lock
: Current programme is being recorded
Do this
Press "/1.
Press %. Press 2 +/- to set the
volume level.
Press 1 on the TV.
Press 2 + (increase)/
- (decrease).
Press %. Press again to restore.
Press
channel, press
.
To access the Input signal index
table, see page 18.
. To select an analogue
F f
/ , then press
Continued
13
GB