Turning On The Camcorder - Panasonic Palmcorder PV-GS59 Operating Instructions Manual

3
While holding the Memory Card with its
cut corner facing right
into/from the Card Slot.
4
Close the Card Slot Cover securely.
Removing the Card
Open the Card Slot Cover and press the center of
the Card and then pull it straight out.
• After removing the Card, close the Card Slot
Cover.
• The Camcorder may be damaged if the Card is
forced out when the Card is fully inserted.
Concerning the Write Protection
Switch on the SD Memory Card
The SD Memory Card has a write protection
switch on it. If the switch is moved to [LOCK], you
cannot write to the card, erase the data on it, or
format it. If it is moved back, you can.
Concerning the Card
• Do not touch the terminals on the back of the
card.
• Do not format the card with another Camcorder
or any personal computer. This operation may
make the card unusable.
• Electrical noise, static electricity, or failure of the
Camcorder or the card may damage or erase
the data stored on the card. We recommend
saving important data on a personal computer by
using a USB Cable, PC Card Adaptor, and USB
Reader/Writer.
SD Memory Card
• The memory capacity indicated on the SD
Memory Card label corresponds to the total
amount of capacity to protect and manage
the copyright and the capacity available as
conventional memory for a Camcorder, personal
computer or other equipment.
Card Access Lamp
While the Camcorder is accessing the Card (reading,
recording, playback or erasing), the Card Access
Lamp lights up.
• While the Card Access Lamp is on, never attempt
to open the Card Slot Cover, to pull out the Card,
to turn off the Camcorder, or to turn the Mode Dial.
Such actions will damage the Card, and recorded
data, and cause the Camcorder to malfunction.
20
, insert/remove it
1
1

Turning on the Camcorder

Turn on the power first and then select modes.
How to Turn on the Power
1
Set the [OFF/ON] Switch to [ON] while
pressing the button
1
2
Open the LCD Monitor or extend the
Viewfi nder to use.
• The [STATUS] Indicator lights Red and turn on
the power.
• The LCD Monitor or Viewfinder will be
activated.
How to Turn off the Power
1
Set the [OFF/ON] Switch to [OFF] while
pressing the button
• The [STATUS] Indicator goes off when the
power turns off.
• In Tape Recording Mode or Card Recording
Mode, if the [OFF/ON] Switch is set to [ON]
while the LCD Monitor and Viewfinder are
closed, the power turns off.
How to turn the power on and off with
the LCD Monitor/Viewfinder
When the [OFF/ON] Switch is set to [ON], the power
can be turned on and off with the LCD Monitor and
the Viewfinder when the unit is in Tape Recording
Mode or Card Recording Mode.
1
Open the LCD Monitor or extend the
Viewfi nder to use.
• The LCD Monitor or the Viewfinder will be
activated.
2
Close the LCD Monitor and retract the
Viewfi nder.
.
1
.
1
1
2