Table of Contents
Advertisement
Caution :
Before closing the Cassette Holder
your fingers have not been placed underneath the
Cassette Holder as shown below. This may cause
your fingers to jam in the cassette holder.
Do not place fingers here.
5
Only after the Cassette Holder is
completely housed, close the Cassette
Compartment Cover by pressing the mark
.
3
When the Cassette Holder does not
come out
• Close the Cassette Compartment Cover
completely, and then open it again completely.
• Check if the battery has run down.
• Check if the Cassette Compartment Cover is in
contact with grip belt as shown below. If so, be
sure the grip belt stays clear of the cover when
opening.
When the Cassette Holder cannot be
housed
• Set the [OFF/ON] Switch to [OFF], then to [ON]
again.
• Check if the battery has run down.
Notes:
• After use, be sure to rewind the cassette
2
, be sure
completely, remove it and put it in a case. Store the
case in an upright position. (p. 74)
• If the indicator of the condensation does not
display on the LCD screen and/or Viewfinder and
you notice condensation on the lens or the main
2
unit, do not open the cassette cover otherwise
condensation may be formed on the heads or the
cassette tape. (p. 73)
• When inserting a previously recorded Cassette,
use the Blank Search Function (p. 31) to find the
position where you want to continue recording.
If you overwrite-record on a previously recorded
cassette, be sure to find the position where you
[Bottom View]
want to continue recording.
• If a new Cassette is inserted, rewind to the
beginning of the tape before starting recording.
• When inserting the cassette, make sure it faces in
the right direction and then push it in until it stops.
• When the Cassette Holder is in action, do not touch
anything except the [PUSH] mark.
3
• Close the Cassette Compartment Cover tightly.
• When closing the Cassette Compartment Cover,
do not get anything, such as a cable, caught in the
cover.
Accidental Erasure Prevention
Opening the accidental erasure prevention slider
1
on the cassette (by sliding it to the [SAVE] arrow
direction) prevents recording. To enable recording,
close the accidental erasure prevention slider (by
sliding it to the [REC] arrow direction).
Using a Memory Card (Optional)
(For PV-GS39/PV-GS59)
A Card can be used to record still pictures.
• Use a genuine SD Memory Card manufactured by
Panasonic only.
Before inserting or removing a Card, be sure to
turn off the Camcorder.
• Otherwise, the Camcorder may not function
properly or it may cause the loss of recorded data
in a Card.
Inserting/Removing a Card
1
2
1
Turn off the Power.
Open the LCD Monitor and then open the
Card Slot Cover.
19
Hide quick links:
Advertisement
Table of Contents
