Further Information - Panasonic Nanoe X F-PXU70M Operating Instructions Manual

FURTHER INFORMATION

The sensor detects air pollutants and shows the pollution level by the PM2.5 concentrations. In auto
operation, the product can optimize the air volume for purifying the air according to the detected
pollutants.
Sensor
Odor from cigarettes, incense, cooking, pets
Gas sensor
Cosmetics, alcohol, sprays, etc.
PM2.5 (0.3 µm ~ 2.5 µm particles)
Indoor dust (dust, dead bodies and excreta
PM2.5 sensor
of ticks, mold spores, pollens, etc.)
Smog (cigarettes, incenses, etc.)
Notice
The sensor's operation may vary depending on the indoor airflow condition if a heater is placed
near the product in a room.
The sensor is not designed to detect bacteria and viruses.
The gas sensor and PM2.5 sensor do not operate when the operation is set to "Off".
Conditions for nanoe
nanoe TM X is generated by using the air in the room. Therefore, due to the differences in
temperature and humidity nanoe
Room temperature: about 5 ℃～35 ℃ (dew-point temperature: 2 ℃ or above)
Relative humidity: about 30%～85%
When nanoe TM
be far less than the level in natural environment such as forest, and not be harmful to human beings.
The product detects the indoor brightness by the light sensor and adjusts the brightness of the LCD
accordingly. When the indoor ambient light gets dark, the LCD dims accordingly.
FAQ
Please confirm the following before you put questions forward or send the product for repair.
Why is a "jee" sound from
the emission outlet?
There is a slight sound when nanoe
is being generated. Depends on the
environment and operation mode, the
sound may be a bit loud or inaudible
but it is not abnormal.
Why does the PM2.5 figure
remain unchanged?
Such problems may occur because
of the difference in sensitivity of
PM2.5 sensor.
14
About gas sensor •PM2.5 sensor
Sensing scope
TM X generation
TM X may not be generated stably.
X is generated, small amount of ozone will be released. However, the quantity will
About brightness reaction
About nanoe TM
TM X
May detect
Humidity (water vapor), oil
The wind generated when a door
is opened or closed, or sudden
temperature changes
Oil, fog-stated water drip
X
Why will air outlet blow out
the odor?
The adsorption capacity of filter
reaches saturation, odor will also be
blown out again with the wind
because of excess adsorption.
The filter has not been cleaned after
getting dirty.
Why has the gas pollution
level display never changed?
Such problems may occur because
of the difference in sensitivity of
PM2.5 sensor.