Table of Contents
Advertisement
USE AND MAINTENANCE INSTRUCTIONS
Clean the dust on surface of louver with a cloth adding neutral cleanser, and then dry
the louver with a soft dry cloth.
nanoe
X exit
TM
TROUBLESHOOTING
Check the product according to the table below if a fault occurs. If the error still occurs,
disconnect all-poles switch of the product, and contact your dealer.
Symptom
· Fan doesn't rotate.
· No wind blows out.
· Running LED light
(blue)doesn't light.
Smells peculiarly
Sounds "zi" lightly
around the orifice.
LED light (blue)
blinks.
Abnormal shaking
or noise
FURTHER INFORMATION
Generating environment
nanoe
X is generated using the air in the room and hence, depending on the temperature
TM
and humidity, there can be incidences whereby nanoe
Conditions for generated
Room temperature: About 5 °C ~ 40 °C (dew-point temperature: more than 2 °C)
Relative humidity: About 30% ~ 85%
Small amount of ozone will be generated
When nanoe
X ion is generated, small amount of ozone will be release. However, the
TM
quantity will be less than the usual lever in forest or natural environment, and not
harmful to human beings.
Cause
Switch is off.
Incorrect wiring
When nanoe
X is generated,
TM
small amount of ozone will
be release. However, it will
be not harmful to human beings.
The sound comes with nanoe
generating. It is hard to detect
it.
The product is in abnormal.
Failure installation of louver
or product abnormal.
Do not insert the finger or
rarity into the nanoe
Otherwise, it may cause short
circuit or electric shock.
Troubleshooting
Turn the switch on.
Contact your dealer.
It is the performance when
product is normally running,
not function abnormal.
X
It is the performance when
TM
product is normally running,
not function abnormal.
Contact your dealer.
Contact your dealer.
(About nanoe
X is not stably generated.
TM
X exit.
TM
X)
TM
7
Advertisement
Table of Contents
