Control Reference Guide; Main Unit; The Unit's Display - Panasonic DMR-EZ485VK Operating Instructions Manual

Control Reference Guide

Main Unit

EJECT
POWER
IN 2 IN 2 S VIDEO S VIDEO
 Cassette eject button .....................................(
 Disc tray open/close button ............................(
 Stop button ...............................................(
 Play/1.3 button ............................................(
 Channel select button ....................................(
 Recording button ............................................(
 DVD/VHS POWER on/off button
(/I POWER) ................................................(
 Press to switch the unit from on to standby mode or vice
versa. In the standby mode, the unit is still consuming a small
amount of power.
 IN2 input terminals ........................................(

The Unit's Display

 Recording indicator
 TV indicator
The indicator lights during TV mode and it goes out during VCR
mode. You can switch the mode by using [VCR/TV] (
 Main display section
 Tape indicator
 Progressive indicator
This indicator lights up when you select "24p" in "Progressive/
24p" ( 51).
6
RQT9056
Remote Control Cassette
signal sensor compartment
VIDEO L L /MONO AUDIO R /MONO AUDIO R
VIDEO
The unit's display
OPEN/CLOSE
DRIVE SELECT
Opening
CH CH
the front panel
15)  DVD/VHS drive indicator ................................(
 Lights when the DVD or VHS drive is selected.
15)
 Drive select button .........................................(
17, 18)
 Drive changes each time you press [DRIVE SELECT].
17)
 Reset button ...................................................(
13)
 DV IN terminal (for a digital video
18)
camcorder) .....................................................(
 SD card slot ....................................................(
12)
 USB port ........................................................(
 One touch copying operation button
 From VHS to DVD ......................................................
28)
 From DVD to VHS ......................................................
 Scheduled recording indicator (
On:
When a scheduled recording program is registered and a
recordable disc or tape is inserted.
Flashes:
16).
The scheduled recording indicator fl ashes when the unit cannot
go to scheduled recording standby (e.g. there is no disc or tape,
etc). It does not fl ash if Quick Start is off.
 Disc indicator
This indicator lights up when a disc that is supported by this unit
is inserted.
Disc tray
CH CH REC
SD CARD
RESET
Pull down.
REC
COPYING COPYING
19)
COPYING COPYING
17)
17)
81)
29)
15)
15)
( 20)
( 21)