Procedure 3.2 - Accessing The Diagnostic Program - Precor C542i Manual

Procedure 3.2 - Accessing the Diagnostic Program

The EFX diagnostic software cycles through the following tests:
• Display Test
• Keyboard Test
• Heart Rate Test
• Battery Test
• RPM Test
• Lift Test
• Brake Test
Procedure
1. Start pedalling and continue to pedal as you perform step 2.
With the PRECOR banner scrolling, press keys RESET,5,1,7,6,5,7,6,1., sequentially.
2.
The message HARDWARE VALIDATION will be displayed for a few seconds.
3.
The message DISPLAY TEST will be displayed followed by every LED on the display being
4.
illuminated. Check each LED segment to ensure that all of the segments are illuminated.
Press the ENTER key to advance to the keyboard test.
The message KEYBOARD TEST will be displayed followed by a graphical representation of
5.
each key position on the display housing. As each key on the display is pressed the key
representation is turned "off", indicating that the key is functioning. Check each key in this
manner, including the numeric keyboard. Press and hold the ENTER key for 2 seconds to
advance to the heart rate test.
The message HEART RATE TEST will be displayed followed by the unfiltered (U), filtered
6.
(F) and polar (P) heart rate readings if the heart rate option is installed in the EFX and a
chest strap transmitter or a test transmitter is being used. If the heart rate option is not
installed in the EFX the message NO HEART RATE RECEIVER will be displayed instead of
the heart rate readings. Press the ENTER key to advance to the brake test.
The message BATTERY TEST will be displayed followed by the battery voltage. Press the
7.
ENTER key to advance to the RPM test.
The message RPM TEST will be displayed followed by the pulse (power bit) reading and the
8.
RPM reading. Press the ENTER key to advance to the lift test.
The message LIFT TEST will be displayed followed by the ramp level and A/D (analog to
9.
digital) reading. The A/D is the number the system use to track the lift position. The A/D
number will be used in the lift calibration portion of this service manual. (Procedure 5.3).
C542i Elliptical Fitness Crosstrainer
Page 8