Table of Contents
Advertisement
Figure 3-2 Top panel of outdoor unit
Function
Location
Antenna
Top
Signal &
Bottom
Power
Antenna
Bottom
alignment
3.3.
The Indoor Unit
The indoor unit is a network/power injector which is used to combine the signal stream and DC power into
single category-5 cable to connect outdoor unit. It has three ports.
Function
Name
Power
POWER
Ethernet
TO LAN
Signal & Power
TO RADIO
4. Configuring G-6000
This guide shows you the default factory configuration of G-6000 and how to configure the G-6000 for
appropriate operation at the first time. See the User's Guide for configuration details.
4.1.
Default Configuration
The G-6000 is shipped with following factory default configurations:
LAN IP
Subnet Mask
Wireless ESSID
Username/Password
Table 3-1 Connectors of outdoor unit
Label
Interface
N male RF connector with
special water proof
8-pin female connector
with special water proof
8-pin male connector with
special water proof
Table 3-2 Connectors of indoor unit
Connector
Power jack
RJ45
RJ45
Table 4-1 Default configuration
192.168.1.1
255.255.255.0
Wireless
admin/1234
Figure 3-3 Bottom panel of outdoor unit
Description
Connecting to the outdoor antenna
Connecting to the indoor interface unit
supplying the power and signal
Connecting to AK-100 for antenna
alignment
Description
Connecting to the outdoor antenna
User for CPE connection via straight through
Ethernet cable
Used for outdoor unit connection via special
waterproof category-5 cable
BU
7
RU
192.168.1.1
255.255.255.0
Wireless
admin/1234
Advertisement
Table of Contents
