Table of Contents
Advertisement
Figure 2-2 Top panel of outdoor unit
Function
Location
Label
Antenna
Top
Signal &
Bottom
Power
Console
Bottom
2.3.
The Indoor Unit
The indoor unit is a network/power injector which is used to combine the signal stream and DC power into single
category 5 cable to connect outdoor unit. It has three ports.
Function
Name
Power
POWER
Ethernet
TO LAN
Signal & Power
TO RADIO
3. Configure B-6010/B-6020
This guide shows you the default factory configuration of B-6010/B-6020 and how to configure the B-6010/B-6020
for appropriate operation at the first time. See the User's Guide for configuration details.
3.1.
Default Configuration
The B-6010/B-6020 is shipped with following factory default configurations:
Operation Mode
DHCP
LAN IP
Subnet Mask
DHCP IP Pool
Wireless ESSID
SMT password
3.1.1
Configuration Requirements
In order to configure the B-6010/B-6020 by using the console port, a computer is needed and installed with
communications software configured to the following parameters:
VT100 terminal emulation
B-6010/B-6020 Secure Outdoor Ethernet Radio Link
Table 2-1 Connectors of outdoor unit
Interface
N male RF connector with
special water proof
8-pin female connector
with special water proof
8-pin male connector with
special water proof
Table 2-2 Connectors of indoor unit
Connector
Description
Power jack
Connecting to the outdoor antenna
RJ45
User for CPE connection via straight through
Ethernet cable
RJ45
Used for outdoor unit connection via special
waterproof category 5 cable
Table 3-1 Default configuration
AP
Router
Server
192.168.1.1
255.255.255.0
192.168.1.33 – 192.168.1.64
Wireless
1234
Figure 2-3 Bottom panel of outdoor unit
Description
Connecting to the outdoor antenna
Connecting to the indoor interface unit
supplying the power and signal
Connecting to the PC for diagnostics &
troubleshooting
AC
Router
Server
192.168.2.1
255.255.255.0
192.168.2.33 – 192.168.2.64
Wireless
1234
4
Advertisement
Table of Contents
