Smart Media Detection; Gap Sensor Auto Calibration Mode; Procedure To Run The Calibration - BIXOLON SLP-TX403 User Manual

5-5 Smart Media Detection

Printer executes this function when necessary without user input and media
configuration can be completed with Smart Media Detection function for most print
papers.
Papers with gap and black mark can be identified without separate settings.
3 ~ 5 pages of labels will be used depending on the type of paper.
Smart Media Detection function is executed in the followings cases
- When the printer is installed first time, it is executed through Feed button or print
command.
- When change paper length is detected during feeding or printing.
- When the paper type entered by command is different from the configured paper type.
- After reset with factory settings
Smart Media Detection function will be turned off after setting the sensor sensitivity using
Automatic Calibration Mode or Manual Media Calibration mode, and it will be enabled
again after resetting the printer with factory settings.

5-6 Gap Sensor Auto Calibration Mode

Use this mode when paper is not detected correctly with Smart Media Detection function.
Printer feeds paper and calibrates Gap Sensor automatically.
The printer will enter error mode if paper detection fails after feeding up to 1 meter of paper.
Error mode can be released by opening and closing the cover.
Use Manual Calibration Mode if paper detection fails in this mode.
Smart Media Detection will be disabled if paper detection is successful in this mode.

5-6-1 Procedure to run the calibration

• Press the Feed button at 4th LED sequence in 5-2-2 (LED 1 Orange / LED 2
Green – Blink four times) to start Gap Sensor Automatic Calibration Mode.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
V10 CONSUMIBLES S.L.