Fujitsu ScanSnap S300 Getting Started Manual page 19

• When using the USB bus power cable, the personal computer must
ATTENTION
have two USB ports; one for power feeding, the other for USB cable
connection.
• When connecting with the USB bus power cable via a USB hub, use a
powered hub equipped with an AC adapter.
• When the scanner is connected with the USB bus power cable, the
scanning speed becomes slow.
Double-sided color documents of A4 or letter in size can be scanned
at a speed of:
Power-cable-connected: Approx. 8 sheets/minute
USB-bus-power-cable-connected: Approx. 4 sheets/minute
(when used with a computer with Intel
higher that runs Windows 2000, Windows XP or Windows Vista and with
Scan mode set to Normal, Color mode Auto, and Compression rate 3, and
others set to defaults)
When connecting with the Power cable:
•
Use the power cable
1. Connect the Power cable.
Remove the adhesive label covering the USB and Power connectors.
Connect to the ScanSnap's power connector and an outlet.
2. Connect the USB cable.
Connect the USB cable to both the ScanSnap and personal computer.
USB port
3. After power and USB ports are connected with cables, perform the
procedure described in "Turning the ScanSnap ON" (page 20).
and USB cable
USB connector
PC
® ®
Celeron M 430 1.73 GHz or
.
Power connector
ScanSnap S300 Getting Started
18