Cursor Is Not Tracking Pen; Tablet Is Not Responding To The Pen; Audio Volume Too Low; Configuring Peripherals Interfaces - Fujitsu Stylistic LT 800P User Manual

S t y l i s t i c L T 8 0 0 P T a b l e t
• The distance between the two devices must not be more than approximately 3
feet or 1 meter.
• The viewing angle from the IrDA port on the tablet must not be more than 15
degrees from a center line between the IrDA port on the tablet and the IrDA
port on the other device.
• The device with which you are trying to communicate must be compliant with
the IrDA Standard Revision 1.1 (or 1.0).

Cursor Is Not Tracking Pen

If the cursor on the screen appears to be misaligned with the pen or is not accurately
tracking the pen, calibrate the pen. See "Calibrating the Pen" in Chapter 2 for
details.

Tablet Is Not Responding to the Pen

If your tablet is not responding to the pen, connect an external keyboard to the
system to see if it responds to keyboard commands. If the system doesn't respond to
the keyboard, the application or system may have crashed, and it may be necessary
to reset the system.

Audio Volume Too Low

If the audio volume on your tablet speaker or external headphones is too low, check
the following:
• Ensure that the speaker (or headphone output if using headphones) is enabled.
To do so, tap the Speaker Mute hotpad. The system beeps when the speaker or
headphone output is turned on using the hotpad.
• Ensure that the volume level set with Volume hotpads is set to an audible level.
• Ensure that the mute box in the system volume control (accessible from the
system tray) is not set.
• Ensure that any volume control in the audio software is set to an audible level.

Configuring Peripherals Interfaces

Certain peripheral devices can be disabled during the BIOS Setup. If the peripheral
interface you want to use does not appear to be working with your peripheral device,
ensure that it is enabled in the BIOS. Contact your local help desk or reseller if you
need assistance using BIOS Setup.
50
2
2
2
2