S t y l i s t i c L T 8 0 0 P T a b l e t
Checking the Connectivity
1. Click [Start] -> [Settings] -> [Control Panel].
2. Double-click the [PRISM Settings] icon. [PRISM Wireless Settings] appears.
3. Check the connectivity on the [Link] tab. The current condition of connection is
displayed.
Item
State
Current Channel
Current Tx Rate
[Radio Off]/
[Radio On]
[Rescan] button
Throughput
(Bytes/sec)
Link Quality
Signal Strength
80
Shows the current condition of connection.
The MAC address of the other computer to which you are
connected is displayed when the connection is successful. If you are
connected to more than one computer, the computer that has the
best connectivity is displayed.
Shows the current channel used for the connection.
Shows the current transfer rate in Mbits/sec.
Click [Radio Off] to disconnect.
Click [Radio On] to connect to the network.
Click this button to search for others to connect to.
Shows the actual transfer rate of the data transfer for send (Tx) and
receive (Rx).
Shows either [Excellent], [Good], [Fair], [Poor], or [Not Connected],
depending on the link quality.
Not shown for AdHoc connection.
Shows either [Excellent], [Good], [Fair], [Poor], or [Not Connected],
depending on the signal strength.
Not shown for AdHoc connection.
Table A-7 Checking connectivity
Description
6