Canon BP-511 Instructions Manual page 137

Shooting
Unable to shoot or CF card is not loaded correctly.
record images
CF card is full.
The battery pack is out of power.
Image out of focus (In-focus light in the viewfinder blinks).
LCD monitor Dust or foreign matter on the monitor.
displays and
images are hard to LCD monitor is worn out.
see
Images are blurred Lens focusing mode switch set to <MF> (or < M>).
Camera shake when the shutter button is pressed.
Unable to use the CF card data is corrupted.
CF card
The message The date/time battery is exhausted.
" " appears on
the LCD panel
Checking and Handling Images
Cannot erase Images may be protected.
images
Incorrect date and Date/Time setting may be incorrect.
time displayed
No image appears Video cable plugs are not inserted fully.
on the TV screen
The correct video format (NTSC or PAL) has not been set.
Load the CF card correctly. ( 28)
Change to a new CF card, or erase unwanted images. ( 28, 43,
104)
Charge the battery pack. ( 22)
Press the shutter button down halfway to focus again. If this fails,
focus manually. ( 29, 59)
Clean the monitor with a soft eyeglass cloth.
Consult the store where you bought your camera, or a Canon
Service Center. ( 10, back cover)
Set the focusing mode switch to < AF >. ( 27)
Press the shutter button carefully so that the camera does not shake.
( 29, 36)
Format the CF card. ( 105)
Use the specified type of CF card. ( 2, 139)
Replace the battery with a new one. ( 113)
Remove image protection. ( 103)
Set date/time correctly. ( 34)
Insert the video cable plugs firmly all the way. ( 112)
Set the camera to the correct video format to match the TV set.
( 112)
REFERENCE
7
137