Fujitsu Lifebook N6210 User Manual page 60

N6210.book Page 54 Wednesday, May 18, 2005 10:24 AM
L i f e B o o k N S e r i e s U s e r ' s G u i d e
Problem
Memory Problems
Your Power On screen, or Your memory upgrade module
Main menu of the BIOS is not properly installed.
setup utility information,
does not show the correct
You have a memory failure.
amount of installed
memory.
Modem Problems
Messages about modem Messages about operation are
operation. generated by whichever
modem application is in use.
USB Device Problems
You have installed a USB The device is not properly
device, but your LifeBook installed.
notebook does not recog-
The device may have been
nize the device, or the
installed while an application
device does not seem to
was running, so your notebook
work properly.
is not aware of its installation.
Your software may not have
correct software driver active.
You may have the wrong I/O
address selected for your
device.
Your device and another device
are assigned the same I/O
address.
PC Card Problems
A card inserted in the PC The card is not properly
Card slot does not work or installed.
is locking up the system.
Your software may not have
the correct driver active.
The card may have been
installed while an application
was running, so your notebook
is not aware of its installation.
You may have the wrong
I/O address selected for your
PC Card device.
Your PC Card device and
another device are assigned the
same I/O address.
54
Possible Cause
Remove and reinstall your memory upgrade
module. (See Memory Upgrade Module on page 45
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 59 for more
information)
See your application software documentation for
additional information.
Remove and reinstall the device. (See Device Ports on
page 47 for more information)
Close the application and restart your LifeBook
notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 25 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Remove and reinstall the card. (See Removing PC
Cards on page 43 for more information)
See your software documentation and activate the
correct driver.
Close the application and restart your LifeBook
notebook.
See your PC Card documentation to determine
the required I/O address. Change the settings in
the BIOS. (See BIOS Setup Utility on page 25 for
more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Possible Solutions